![mr configurator manual mr configurator manual](https://www.mymitsubishisupport.co.za/wp-content/uploads/2020/04/1-2-480x439.png)
MR CONFIGURATOR MANUAL SERIAL NUMBER
The default login is the serial number (e.g.
MR CONFIGURATOR MANUAL HOW TO
The following procedure describes how to set the static IP:
![mr configurator manual mr configurator manual](https://www.distrelec.nl/Web/WebShopImages/landscape_large/1-/01/30091871-01.jpg)
While holding the AP with one hand, press the cradle’s bottom tab upwards, releasing the AP from the bottom of the cradle. To release the AP from the mount cradle, first remove the security screw that secures the AP to the cradle’s bottom tab. Once in place, the AP should be secured to the cradle by using one of the included screws in the cradle’s bottom tab. T hen adjust the AP to guide the AP ’s bottom slot into the cradle’s bottom tab until it clicks into place. Since the cradle is already mounted to the wall, guide the AP towards the top tab and i nsert the top tab into the AP ’s slot. To attach the AP to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle. The AP attaches to the mount cradle with two tabs on the cradle that insert into the AP, and is secured to the cradle using one screw. Where you have already installed the mount cradle.) (This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount If mounting your AP to a dropped ceiling, skip to the "Power the AP " section. The mount cradle can then be held with one hand while the other hand holds a screwdriver. Tip: Pre-assemble rubber spacers and screws to the mount cradle.